Sorry, you need to enable JavaScript to visit this website.

Characterization of WEEE plastics and their potential valorisation through the production of 3D printing filaments

TitleCharacterization of WEEE plastics and their potential valorisation through the production of 3D printing filaments
Publication TypeArticolo su Rivista peer-reviewed
Year of Publication2021
AuthorsCafiero, Lorenzo M., De Angelis Doina, Di Dio M., Di Lorenzo P., Pietrantonio Massimiliana, Pucciarmati Stefano, Terzi R., Tuccinardi Letizia, Tuffi Riccardo, and Ubertini A.
JournalJournal of Environmental Chemical Engineering
Volume9
ISSN22133437
Keywords3-D printing, 3D printers, 3D-printing, ABS resins, Elastomers, Filament, Materials recovery facilities, Mechanical recycling, Oscillators (electronic), plastic, Plastic products, Plastic recycling, Plastic sample, Recycled plastics, styrene, Valorisation, Waste of electrical and electronic equipments
Abstract

Plastic is probably the fraction of the waste of electrical and electronic equipment (WEEE) most challenging to manage and the market of recycled plastics from WEEE is limited to few cases. In this study, twenty WEEE plastic samples collected in two material recovery facilities (MRFs) from manually sorted housings and components and among some discarded devices stored in Casaccia Research Center were analysed through infrared identification and chemical-physical characterization. The analyses were carried out in order to select the suitable samples for mechanical recycling in 3D printer filaments. Eleven different polymers or blends were found in the WEEE samples and the majority of those collected in the MRFs resulted as mixtures of different plastics, although often of styrene-based nature. On the other hand, many WEEE samples showed a good similarity to the corresponding virgin polymers with a content of halogens and inorganic fillers less than 0.2 and 5 wt%, respectively. The thirteen selected WEEE plastic samples were washed, reduced to < 4 mm and extruded in filaments with the proper diameter. The polymeric heterogeneity and the presence of foreign materials in some samples were the main critical issues highlighted during the extrusion. The suitable filaments were used to print test objects with different geometries. The quality control of the scanned objects, through a structured-light 3D scanner, showed that specimens printed with WEEE plastic filaments had no significant higher deviation from the model design in comparison to the same object produced using the commercial filaments. © 2021 Elsevier Ltd.

Notes

cited By 0

URLhttps://www.scopus.com/inward/record.uri?eid=2-s2.0-85105050779&doi=10.1016%2fj.jece.2021.105532&partnerID=40&md5=0d7da4242230dc14bd001abc57ed901e
DOI10.1016/j.jece.2021.105532
Citation KeyCafiero2021